Tarmac driveways in Derby
We dig out, edge and lay tarmac driveways across Derby and the surrounding area. Every photo on this page is from our own jobs.
How a tarmac drive goes in
Every drive is different, but the job runs in the same order: dig out, edge, lay, roll.
-
Digging out
The old ground is dug out to make room for the new drive.
-
Edging and drainage
Block or brick kerbs go in along the edges. On some drives, a channel drain goes in as well.
-
Laying
The tarmac is raked out to an even level.
-
Rolling
Then the roller goes over it.
Tarmac going down, on video
Two short clips from our own jobs: tarmac coming in by grab onto the stone base, and tarmac barrowed in and spread out on a drive. Then it’s raked out level and rolled.
One drive, start to finish
The same drive three times: the stone sub-base going down over the dug-out ground, the sub-base laid up to the channel drain along the house, then the finished tarmac, edged in block paving.
-
Dug out, with the stone sub-base starting to go down. -
Sub-base laid up to the channel drain. -
The finished drive, up to the front door.
Finished drives
A neat block or brick edge. Some drives also get a channel drain, either across the front where the drive meets the pavement or along the house.
-
Block edging where the drive meets the pavement. -
A channel drain set between rows of block edging. -
Block edging, with a channel drain across the front. -
A finished drive: block edging, and a channel drain where it meets the pavement.
You’ll probably need a dropped kerb too
A new driveway usually needs a dropped kerb, so you can drive on from the road. That needs the council’s permission before it’s built, and the process is different inside Derby and out in the county.
Talk to Gavin about your new drive
Call, email or send the details, and we'll talk it through. We cover Derby and the surrounding area.
Call or email
Tell us what you need and roughly where you are.
07706 329 848Or email [email protected]